Get Your Bike Ready For Spring

Simple Tasks Can Result In Smooth Performance

Now that spring is approaching, many riders in the northern reaches of the country are faced with getting their motorcycles back in shape for the riding season.

If you didn’t do much more than park your bike on the side of the garage when the first cold winds blew last fall, you’ve got a little work ahead of you.

Suffice it to say that prepping a bike for winter is usually a lot easier than getting an unprepped bike ready for spring. That’s because several things have been going on over the past four months that could make your life difficult now.

Foremost is the fuel system. Gasoline is a mixture of volatile chemicals, and when it sits untreated for several months, parts of the mixture can evaporate, leaving behind a brown gunk called varnish.

Varnish can clog the small jets inside a carburetor or a fuel injector, leading to sluggish performance, difficult starting or even no starting.

You’ll at least want to drop the float bowls on the carbs, dump out the gas that remains, and clean out any residue with carb cleaner. In addition, you may need to unscrew the jets and clean them, too.

Preventing this next year is as easy as squirting a bit of fuel stabilizer into your last tankful before winter. Then run the engine for a few minutes to get treated fuel into the carbs and injectors.

If your gas tank was low when you parked the bike last year, it’s possible that condensation has formed in it. Draining all the remaining fuel and replacing it with fresh gas is your best bet.

Your battery may well be dead or nearly so, if you didn’t remove it from the bike and connect it to a trickle charger before you stored the bike.

Pull the battery and check it. Replace it if necessary.

If it is an older battery, add distilled water to any cells that need it, and put it on a trickle charger. You can use a hydrometer to tell when it’s ready to use.

You’ll also want to be sure that your tires contain the recommended air pressure, that your brakes work smoothly and have adequate fluid, that your chain is oiled and your air filter is clean.

Yes, it may seem like a lot to do.

But these are all things you’d more than likely have to do sometime soon anyway. Consider it getting a jump on your bike maintenance for the year.